Skip to content
JOY TECH — Concrete Polishing Tools logo

Edge Polishing With Smaller Discs: Speed and Pressure

Scroll

Edge Polishing With Smaller Discs: Speed and Pressure

2026-11-19•JTJOY TECH Engineering Team
Edge Polishing With Smaller Discs: Speed and Pressure

Quick Answer

Use lower speed and lighter pressure than you would on the field. A small disc has a higher rim speed at the same rpm, so it heats faster. Keep the disc flat, overlap the field by one disc width and use short passes.

Why Small Discs Behave Differently

A 3 in disc at 1,000 rpm has a lower rim speed than a 7 in disc at the same rpm, but the contact area is smaller. The same pressure is concentrated on less area, so the edge cuts deeper and heats faster.

The operator also tends to tilt a small tool to reach the corner. That reduces the contact area further and creates a taper.

Speed Settings

Start at half the speed you use on the field. If the edge burns or the pad glazes, reduce speed further. If the edge is slow to cut, increase pressure slightly before increasing speed.

Pressure and Passes

  • Let the tool weight do most of the work.
  • Use overlapping passes along the wall.
  • Do not stop in one spot; keep the disc moving.
  • Check the edge every two passes under raking light.

Frequently Asked Questions

Q: Can I use the same rpm as the field?

A: Usually not. Start lower and adjust by the edge temperature and cut.

Q: Why does the edge burn?

A: Too much speed, too little water or a stopped disc. Reduce speed and keep the disc moving.

Q: How do I match the edge to the field?

A: Use the same grit sequence and overlap the field by one disc width.

Conclusion

Edge work is about control, not power. A 3 in resin pad handles the final edge; a two-ring concrete pad gives more cut on rough edges.

Products used in this guide

Need this tool for your job?

MOQ 1 · 7–30 days by order quantity · FOB & CIF · free sample on request

Get a factory quote

Share this article

Author & Manufacturer

Written and reviewed by JOY TECH - an SGS & BV audited, CE/RoHS certified diamond tools manufacturer founded in 2004, exporting to 50+ countries.

Quality & Compliance

Our factory and quality management system are audited by SGS and Bureau Veritas. Products meet CE/RoHS requirements and every piece is 100% inspected before packing.

Verified Certificates

  • • SGS Audited Supplier — Report No. QIP-ASI227442 & QIP-ASR247051
  • • Bureau Veritas Verified — Report No. MIC-ASR257059
  • • CE & RoHS Certificate of Conformity — No. CS240925001HRZ

Request a Factory Quote

Average response time: under 24 hours

Or WhatsApp: +86 185 5928 2197 · [email protected]

FAQ

GET A QUOTEWhatsApp