
Honing vs Polishing: When to Stop
Honing vs Polishing: When to Stop

Quick Answer
Honing removes scratches and levels the surface; polishing builds gloss. Stop honing when the surface is flat, the scratch pattern is uniform and the aggregate is fully exposed to the spec. Move to polishing when the floor is ready to reflect light, not before.
What Honing Does
Honing is the intermediate stage. It removes the deep scratches from the metal bond and prepares the surface for the finer resin steps. A honed floor can look clean and matte, but it is not polished.
Honing usually covers 50 to 200 grit. The exact range depends on the floor and the finish.
What Polishing Does
Polishing starts when the surface is flat and the scratches are fine. It builds gloss with 400 grit and finer pads. If the floor still has deep scratches, polishing will only make them shiny.
When to Stop Honing
- The surface is flat under a straightedge.
- The scratch pattern is uniform across the floor.
- The aggregate is exposed to the specified level.
- No previous grit scratches remain under raking light.
Frequently Asked Questions
Q: Can I polish a floor that is not flat?
A: No. Polishing highlights the low spots. Flat the floor first.
Q: Is 200 grit the end of honing?
A: It depends on the spec. Some floors need 400 before polishing; others start gloss at 200.
Q: Why does the floor look dull after honing?
A: Honing leaves a matte surface. Gloss comes from the polishing steps.
Conclusion
Stop honing when the surface is flat and the scratch is uniform, then polish. A copper-bond transition pad helps bridge to resin; a refined polishing pad builds the final gloss.
Products used in this guide

Copper Bond Diamond Transitional Polishing Pads (JOY-RFP-C2)
View specs →
4'' Refined Polishing Pad (JOY-HP-01)
View specs →Need this tool for your job?
MOQ 1 · 7–30 days by order quantity · FOB & CIF · free sample on request
Author & Manufacturer
Written and reviewed by JOY TECH - an SGS & BV audited, CE/RoHS certified diamond tools manufacturer founded in 2004, exporting to 50+ countries.
Quality & Compliance
Our factory and quality management system are audited by SGS and Bureau Veritas. Products meet CE/RoHS requirements and every piece is 100% inspected before packing.
Verified Certificates
- • SGS Audited Supplier — Report No. QIP-ASI227442 & QIP-ASR247051
- • Bureau Veritas Verified — Report No. MIC-ASR257059
- • CE & RoHS Certificate of Conformity — No. CS240925001HRZ
